![]() ![]() This is on page 15 of the manual I linked. If the clutch is slipping due to the reasons above, fix the problem, don't adjust the slip clutch. The installer must validate that the crankshaft OE number. Water on the cover, low pool water level, bad track pulleys, and dirt or debris in the track can all cause the clutch to slip. Clutches contaminated by oil and grease are not eligible for warranty replacement/refund. Once you have the cover moving well on its own, then the next thing I would check is the slip clutch: "Make sure there is nothing interfering with the cover operation before adjusting the slip clutch. Sliders / Gliders - injected molded polymer components that attach to the rope(s) on the cover fabric which runs in the track channel. I would also check the rope track and make sure it is clean. to the Pool Cover Dealer, Distributor or Pool Cover Owner. Getting to know More about us Testimonials. Key Information:-Only 1 key FREE ground shipping on orders over 250.00. If it hasn't been used in a while one or more of the pulleys could be frozen and creating too much friction. costs for replacement or repair of warranted parts from Automatic Pool Covers, Inc. This a key for a Aquamatic Key Switch that opens and closes the pool cover. I would do at least a partial manual close/open to check the ease of moving the cover and ropes through the tracks and pulleys. Otherwise your shaft or double dogs are likely worn or broken. If you do have a sheared pin, then it would seem that your cover ropes might be stuck or too tight which caused the shear pin to break protecting your gears and pulleys. Also your mechanism shouldnt shift like that each time it catches. ![]() Otherwise your shaft or double dogs are likely worn or broken. Mine does this with just a little water on top. The Hydramatic cover is UL tested and certified to exceed ASTM F1346-91. The screen mesh will collect the leaves and most debris. ![]() You are lucky that the motor is running well it appears - Check if you have a shear pin as others have mentioned above (Not sure a T3 does - mine is a T3 also). I think it got hung up on something and then snapped. Our exclusive patented built-in rainwater removal feature eliminates accumulated rainwater on the cover surface by simply turning the key to open the cover, the water is forced through the screens into the pool. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |